Sauna Builder in Hollywood, CA

In Los Angeles most home sauna installations land in a wide band depending on room size, heater and how much of the space has to be rebuilt. A small two-person indoor conversion in an already framed closet is the low end. A six-person cedar room with a premium heater, new circuit and glass door is mid-range. Outdoor cabins with a foundation, roof and buried electrical run are the top end. We quote flat-rate after a site visit, with the heater, wiring, venting and permit included.

Nearly every electric sauna heater needs a dedicated 240V circuit with no other loads on it. A 4.5kW heater typically needs 30 amps, a 6kW heater 30 to 40 amps, a 8 to 9kW heater 40 to 50 amps and a 10.5 to 12kW heater 60 amps. The wire has to be sized for the run length and the heater has to be hard-wired, not plugged in. We check your panel capacity first, because older Los Angeles homes on a 100-amp service often need a subpanel or a service upgrade before a large heater is viable.

Not legally in Los Angeles, and not safely. The dedicated 240V circuit requires an electrical permit in every jurisdiction we work in. Framing a new room or building an outdoor structure adds a building permit, and a wood-fired heater adds a combustion and venting permit. Unpermitted work turns into a problem at resale, during an insurance claim, or on the day something fails. We pull every permit as part of the install and coordinate the inspections.

An indoor conversion in a space that is already framed usually runs one to two weeks on site once materials arrive, plus permit lead time. A full closet or garage conversion runs two to three weeks. Outdoor builds with a foundation take four to six weeks. The heater and wood order is normally the longest lead item, so we place it as soon as the spec is signed.

We install across the major brands and can spec efficient units in any of them. On the electric side, look for heaters with well-insulated cabinets, high stone mass and a modern digital control with a scheduling timer, because holding heat efficiently matters far more than the nameplate rating. On the steam side, look for auto-drain and auto-flush generators, which use less water and last considerably longer in hard-water areas like ours. We are not tied to one manufacturer, so we will spec whatever fits your room and budget.